Heat Pump Sound Check
Live input
– dBFS
Tap “Start microphone” and point the phone at the heat pump
Recording conditions
Tips: hold the phone steady ~1 m from the unit, don't cover the microphone, avoid wind and talking. Record in the same position & mode each time for reliable comparisons.
Fingerprints
    Compare two recordings
    Trend over time

    Similarity is measured against the baseline of the group (★ in the library).

    Installation
    Technician
    Analysis

    Calibration: hold a sound level meter next to the phone and enter the difference (meter reading − app reading) to show approximate absolute levels. Without calibration all levels are relative dBFS, which is fine for comparing recordings made with the same phone.

    About

    All recordings and fingerprints stay on this device until you send them. The automated findings are hints based on frequency analysis – they don't replace an inspection by a qualified technician.

    Built with Meyda, fft.js, Chart.js, wavesurfer.js, Dexie, jsPDF and JSZip.

    Send to technician